Injection Molding

  • Able to do traditional Injection molded prototype parts
  • Hand loads are used to shorten the time required to produce tooling
  • Much of our plastic work consists of over molding metal stampings
  • Size capacity—Most molded parts are smaller than 24” x 24”
Injection Molded Metal Piece

Wire and Tube Forming

  • Wires and tubes are primarily used by seating customers
  • Capability to form wires up to ½” thick
  • Depending on wall thickness for tube bending, our capabilities are up to 3 1/2”
Shaped Steel Tubing

Take a virtual tour of our factory floor!


This website uses cookies and third party services. Ok